Skip to content

BendBoard 008

Stepped profile. Level changes and strip details in ceilings.

502050

Cross-section, dimensions in mm. Board thickness 12.5 mm.

About this profile

BendBoard 008 is a hat-shaped section that forms a small 20 × 20 mm step between two 50 mm legs. Depending on which way it is fixed, it creates a fine shadow gap or a slightly raised decorative strip in a plasterboard ceiling. It is the smallest step in the stepped family and is meant for slim line details; for a clearly visible level change, BendBoard 009 is the larger option.

Where it is used

  • Fine shadow gaps where a ceiling meets a wall or a change of finish.
  • Slim raised strips that divide a large plasterboard ceiling into panels.
  • Edges of ceiling recesses that need a small but crisp offset.

On site

Both folds are made in one piece, so the 20 mm step is the same at every point of the run, which matters because any variation shows in a fine shadow line. Screw both 50 mm legs to framing.

At this scale, filler closes up the step very quickly. Mask it or work around it carefully to keep it sharp, and place end joints on the 50 mm legs, aligned with each other.

Made to measure

Step height, step width and the 50 mm legs can all be changed, with steps starting from 20 mm. Send the step dimensions and the total length of line needed.

Installation detail

Technical drawing showing how the profile connects to the metal framing.

BendBoard 008 installation detail 1: connection to the suspended ceiling framing

Other stepped profiles