BendBoard 001
Corner profile. 90° transitions at ceiling and wall junctions.
Cross-section, dimensions in mm. Board thickness 12.5 mm.
About this profile
BendBoard 001 combines a 300 mm base and a 70 mm upstand into a 90° corner, finished with a 25 × 50 mm return at the top edge. That return is what sets it apart: it forms a shadow gap along a ceiling edge or a small pocket that hides an LED strip in a light cove. Where a plain drywall corner is enough, BendBoard 002 has the same base and upstand without the return.
Where it is used
- Perimeter light coves where the ceiling stops short of the wall, with the 25 × 50 mm return acting as the pocket that hides the LED strip.
- Shadow-gap edges on bulkheads, where the recessed line repeats exactly on every length.
- Long cove runs in hotel corridors and shop ceilings, where a return built on site would gradually drift.
On site
Screw the 300 mm base to the ceiling framing; the 70 mm upstand and the return then follow the factory folds. Joints between lengths belong on the flat faces, never at a fold.
Paint the inside of the return before the strip goes in, because the pocket is awkward to reach with a roller later. Before fixing the first length, check against the drawing which way the return opens.
Made to measure
The base, the upstand and both legs of the return can be adjusted to suit your light fitting. A dimensioned section sketch and the approximate run length are enough for a quote.
Installation detail
Technical drawing showing how the profile connects to the metal framing.



