Plasterboard corner profiles
Every point where a ceiling meets a wall or a bulkhead face needs a clean 90° corner. BendBoard corner profiles are V-grooved and folded in the factory from 12.5 mm plasterboard, so the corner arrives in one piece, straight and resistant to cracking. No corner beads, cutting or long jointing work on site. Return-edge versions give a crisp finish for shadow gaps and concealed lighting details.
Profiles
Plasterboard corner profiles: a practical guide
Folded plasterboard as a corner bead alternative
On a conventional job, a plasterboard corner is two separate boards meeting at the arris. Each board is cut and fixed, a metal or plastic corner bead or a metal-reinforced paper tape goes on the edge, and the corner is built up with several coats of jointing compound. How straight it ends up depends largely on the crew.
A folded plasterboard profile puts the fold into the board itself. The back of 12.5 mm plasterboard is V-grooved in the factory, the board is folded along the groove and the face paper runs continuously round the corner. There is no bead to fix at the fold, and the joints move off the arris onto the flat faces, where they are finished as normal.
BendBoard 001 and 002: plain corner or corner with return
BendBoard 002 is a plain 90° corner with a 300 mm base and a 70 mm upstand. It suits straightforward transitions where a suspended ceiling turns down onto a wall or a bulkhead face.
BendBoard 001 has the same 300 mm base and 70 mm upstand plus a 25 × 50 mm return. The return gives a defined edge for shadow gaps and concealed lighting, and it sits on the same line on every piece.
Leg lengths, overall length and angle can be made to suit the project. A section drawing or a set of dimensions is enough to start.
Installation on standard framing
The profiles screw directly to standard metal framing for suspended ceilings and partitions, with no special carrier system. Each product comes with an installation detail drawing.
Every piece is made on the same machine setup, so the geometry is identical from one piece to the next. Along a long bulkhead the corner line stays true, which matters in retail and hotel ceilings that are inspected closely.
When a plasterboard corner profile makes sense
Pre-formed corners save the most site work where the same detail repeats many times, where corner runs are long, or where the corner combines with a shadow gap or light cove. For a single short corner, the conventional method may be all you need.
Profiles are made to order, so they belong in the programme and should be ordered once the section is signed off.
- Is a plasterboard corner profile the same as a corner bead?
- No. A corner bead or corner tape is added on site to protect and straighten the joint between two boards. A BendBoard corner profile is one folded board, so there is no bead at the fold and only the joints on the flat faces need finishing.
- What board are the corner profiles made from?
- Standard 12.5 mm plasterboard, V-grooved and folded at our factory in Istanbul and delivered across Europe.
- Can you make angles other than 90°?
- Yes, the angle is made to suit the project. For 150° sloped transitions there is also a separate angled profile family.
- Do the corner profiles need special framing?
- No. They fix to the standard metal framing used for suspended ceilings and partitions.
- What do you need for a quote?
- The profile code or a section drawing, approximate quantities, the project location and the required delivery date.

Get a quick quote for your project.
Share your drawings or dimensions and we will work out the right profile, price and delivery together.

