Skip to content

BendBoard 003

Angled profile. 150° sloped transitions and concealed lighting details.

27570

Cross-section, dimensions in mm. Board thickness 12.5 mm.

About this profile

BendBoard 003 has a 275 mm base and a 70 mm sloped leg set at 150°, ending in a 25 × 25 mm return. The return creates a ready-made pocket for an LED strip along an angled bulkhead, so the light washes onto the ceiling from a softened edge instead of a square one. BendBoard 004 uses the same 150° angle with a wider base and no return.

Where it is used

  • Angled light coves where the LED strip sits in the 25 × 25 mm return and washes light up across the ceiling.
  • Bulkheads in restaurants and shops where a square cove would look too heavy.
  • Lobby and reception ceilings where a softened, lit edge outlines a raised zone.

On site

The 70 mm leg breaks away from the base at 30°, so the return ends up tilted as well. Dry-fit one length and check where the light lands on the ceiling before fixing the rest of the run.

The 25 × 25 mm return is smaller than the one on BendBoard 001. Pick a slim LED profile and check on the section drawing that it fits the pocket before ordering the full run.

Made to measure

Base, sloped leg, return and the 150° angle can all be adjusted. Send the dimensions of the LED profile you plan to use along with your section sketch, so the return can be sized around it.

Installation detail

Technical drawing showing how the profile connects to the metal framing.

BendBoard 003 installation detail 1: connection to the suspended ceiling framing
BendBoard 003 installation detail 2: connection to the suspended ceiling framing

Other angled profiles