Angled plasterboard profiles and bulkheads
Plasterboard profiles folded at 150° for sloped ceiling transitions, angled bulkheads and concealed light coves. Because the angle is set in the factory, every piece has exactly the same slope, with no measuring or mitre cutting on site. Return-edge versions form a ready-made pocket for LED strips. Ideal for soft transitions in retail, hotel lobby and office ceilings; other angles can be produced to suit your project.
Profiles
Angled plasterboard profiles: sloped bulkheads and light coves
How a sloped ceiling transition is usually built
Where a suspended ceiling should meet a wall, or a second ceiling level, with a slope instead of a sharp corner, the usual site method joins two separate pieces of board at an angle. The edges are bevelled, an adjustable-angle corner bead or corner tape goes on the joint, and the arris is filled. Holding an angle other than 90° identical on every piece is much harder than building a square corner.
BendBoard angled profiles have the angle set in the factory. The back of 12.5 mm plasterboard is V-grooved and the board is folded to 150°, with the face paper running continuously round the fold. No measuring or mitre cutting on site, and every piece has exactly the same slope.
BendBoard 003 and 004: 150° with or without a return
BendBoard 003 has a 275 mm base and a 70 mm sloped leg set at 150°, ending in a 25 × 25 mm return. The return forms a ready-made pocket for an LED strip along an angled bulkhead.
BendBoard 004 is a plain chamfer section: a 325 mm base joined to a 70 mm sloped leg at 150°, with no return. It has the widest base in the angled family and suits sloped transitions with no lighting.
Angle, leg lengths and overall length can be made to suit the project. A section drawing or a set of dimensions is enough to start.
Light coves and angled bulkheads
In a cove built with BendBoard 003, the LED strip sits in the pocket formed by the return, so the light washes onto the ceiling from a softened edge instead of a square one. Typical uses are perimeter concealed lighting in retail, hotel lobby and office ceilings.
BendBoard 004 replaces a sharp corner where a suspended ceiling meets a wall, or where two ceiling levels are linked by a slope. Both profiles screw to standard metal framing for suspended ceilings and partitions, the joints fall on the flat faces and are finished as normal, and each product comes with an installation detail drawing.
When an angled profile makes sense
A pre-formed angled profile saves the most site work where the slope runs a long way, where the same detail repeats across several spaces, or where the transition also carries a light cove. For a single short chamfer, joining two boards on site may be all you need.
Profiles are made to order and the angle is fixed in production, so get the section signed off before ordering.
- What does a 150° angle mean on a plasterboard profile?
- The internal angle between the base and the sloped leg is 150°, so the sloped leg turns 30° away from the plane of the base. It gives a much softer transition than a 90° corner.
- Which angled profile should I use for a light cove?
- BendBoard 003, whose 25 × 25 mm return forms a ready pocket for an LED strip. For plain sloped transitions without lighting, BendBoard 004 has no return and a wider base.
- Can you make angles other than 150°?
- Yes, the angle is made to suit the project. For 90° transitions there is also a separate corner profile family.
- Do angled profiles need special framing?
- No. They fix to the standard metal framing used for suspended ceilings and partitions, and each product comes with an installation detail drawing.
- What do you need for a quote?
- The profile code or a section drawing, approximate lengths, the project location and the required delivery date.

Get a quick quote for your project.
Share your drawings or dimensions and we will work out the right profile, price and delivery together.

