BendBoard 004
Angled profile. 150° sloped transitions and concealed lighting details.
Cross-section, dimensions in mm. Board thickness 12.5 mm.
About this profile
BendBoard 004 is a plain chamfer section: a 325 mm base joined to a 70 mm sloped leg at 150°, with no return. It replaces a sharp corner with an angled transition between a suspended ceiling and a wall, or between two ceiling levels. It has the widest base of the angled family; where an LED pocket is needed, BendBoard 003 adds a return.
Where it is used
- Chamfered junctions between a suspended ceiling and a wall, replacing the square corner with a 70 mm sloping face.
- Changes between two ceiling levels where a canted face looks lighter than a vertical one.
- Bevelled edges on bulkheads and service box-outs, where the 325 mm base leaves a wide fixing zone on the ceiling side.
On site
Fix the 325 mm base first and use it to set the line of the run; the sloped leg then lands on the wall or the lower ceiling. Back the line where the sloped leg meets the adjoining surface with framing.
A canted face catches raking light, so end joints need more careful filling and sanding than usual. Plan them on the flat faces, never on the fold.
Made to measure
The standard angle is 150°, but other chamfer angles and leg lengths are made to order. Send the angle and both leg dimensions for a quote.
Installation detail
Technical drawing showing how the profile connects to the metal framing.



