Skip to content

BendBoard 005

Curved profile. Soft corner transitions with an R100 radius.

265.9R100

Cross-section, dimensions in mm. Board thickness 12.5 mm.

About this profile

BendBoard 005 is a curved plasterboard section in which a 265.9 mm flat base runs into an R100 arc with an arc length of 129.1 mm. The arc stops short of a full quarter circle, so the flat face ends in a soft, open curve. That makes it suited to rounded bulkhead noses, column heads and curved ceiling edges. For a full 90° bend with a straight leg on both sides, see BendBoard 010.

Where it is used

  • Rounded noses on bulkheads, where the flat base forms the soffit and the arc softens the leading edge.
  • Column heads that flare softly into the ceiling.
  • Curved ceiling edges in shops and lobbies that should look rounded without turning fully down.

On site

The curve is formed by closely spaced V-grooves, so the face paper runs unbroken over the arc. Screw the 265.9 mm flat base to framing and support the free end of the 129.1 mm arc so it holds its shape.

Work the arc with a curved or flexible trowel rather than a straight edge. Keep end joints in the flat base, where they are easier to hide.

Made to measure

Radius, arc length and base width are all made to measure. For a quote, send the radius, the arc length or angle, and the base width.

Installation detail

Technical drawing showing how the profile connects to the metal framing.

BendBoard 005 installation detail 1: connection to the suspended ceiling framing
BendBoard 005 installation detail 2: connection to the suspended ceiling framing

Other curved profiles